Fcc Compliance Statement; Recommended Separation Distances - AcceleDent OPTIMA Mode D'emploi

ability. The Charging Case shall have two means of protection, as Class II
equipment, in order to prevent the parts from exceeding voltage, current,
or energy limits defined by IEC 60601-1. As a precaution, the USB connector
should not be touched or manipulated when connected to the Power Adapter
and when the Power Adapter is connected to the supply mains. The Power
Adapter can be isolated from the supply mains by unplugging the device. Do
not position the charging case to make it difficult to operate the disconnection
device (USB cable).
10.10. Ingress Protection Class
10.10.1. The Charging Case is rated IP32; it is protected from intrusion of
solid foreign objects greater than 2.5 millimeters, except dust or lint, and
against vertically falling water drops when enclosure is tilted up to 15°.
10.10.2. The Activator is rated IP67; it is protected from total dust ingress and
from immersion between 15 centimeters and 1 meter in depth.

10.11. FCC Compliance Statement

10.11.1. This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
10.11.1.1. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be recognized by turning the equipment off and on, the user is encouraged
to troubleshoot to correct and reduce the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Please contact the OrthoAccel Customer Service.

10.11.2. Recommended separation distances:

BACK TO CONTENTS
18
Page of 51