Lubrication - Ingersoll Rand 2131A Mode D'emploi

LUBRICATION

Ingersoll- -Rand No. 50
Ingersoll- -Rand No. 115- -1LB for routine external
lubrication of the impact mechanism through the Hammer
Case Grease Fitting.
Use Ingersoll- -Rand No. 105- -1LB or Ingersoll- -Rand
105- -8LB when disassembling and assembling the impact
mechanism.
Always use of an air line lubricator with these tools.
We recommend the following Filter- -Lubricator- -Regulator
Unit:
For USA - - No. C18- -03- -FKG0- -28
AIR SUPPLY (FROM COMPRESSOR)
PLACING TOOL IN SERVICE
3/8" COUPLER OR LARGER
(I--R PART NO. MSCF33)
I--R PART NO. MSPM32 (MALE)
I--R PART NO. MSPF32 (FEMALE)
3/8" AIR HOSE
WITH 1/4" NPT FITTINGS
Do not mark any nonmetallic surface on this tool with
customer identification codes. Such actions could affect
tool performance.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
3
FILTER
COMPRESSOR
(Dwg. TPD905- -1)
I--R PART NO. MSPM32
3/8" COUPLER OR LARGER
(I--R PART NO. MSCF32)
(Dwg. TPD1674- -2)