Mounting Blocks To The Block Holder - VHF S5 Mode D'emploi D'origine

EN 28

6.4.1 Mounting blocks to the block holder

You can mount up to 3 blocks to the block holder.
The block type, the number of blocks and the
block positions must correspond to the corres-
ponding job in DENTALCAM.
F . 20 T S5
IG HE BLOCK HOLDER
1. Upper positioning groove
2. Clamping bolt
3. Lower positioning groove
4. Positioning pin (x 3)
5. Hole for block shafts (x 3)
6. Fixing screw (x 3)
1. Use the provided torque wrench to loosen the fix-
ing screw at the desired position.
F . 21 U
IG NSCREWING THE SCREW AT THE DESIRED POSITION
2. If the blank is a multilayer blank, orientate the blank
so that the top color layer is on top.
3. Position the block so that the positioning pin at the
F
IG
GROOVE IN THE SHAFT
4. Insert the shaft of the block into the desired pos-
F
IG
F
IG
5. Use the provided torque wrench to fixate the block
Original Operating Instructions: S5
Version: 12/15/2021
S5 – Operation: Preparing jobs
block holder lies in the groove in the block shaft.
. 22 P (
OSITIONING PINS LEFT MARKINGS
( )
RIGHT MARKING
ition in the block holder until it is firmly seated.
. 23 I
NSERTING A BLOCK INTO THE BLOCK HOLDER
. 24 I
NSERTING A BLOCK INTO THE BLOCK HOLDER
with the corresponding fixing screw. Tighten the
screw firmly.
)
MUST LIE IN THE