Dion-Ag F6313T955 Instructions D'assemblage page 10

Instructions d'installation / Installation instructions : F6313T955
Ensemble Adaptateur F63 / Adapter Kit F63: K27760 for Claas
Step 8: Installation on the harvester

To facilitate the header pick-up, set the header on 4'' à 6'' (10 - 15cm) thick blocks under
the front shoes (33). The blocks will give a better inclination angle for direct pickup with
the harvester.

Set the rear of the header on the provided lift jack in the storage position (34).

Pick up the header and lock the safety hooks. Remove the lift jack and set in transport
position (35).

Drop the head and readjust the lower links (5) position if the hook points are not
aligning properly. Same with the lock handle (21)

Install the drive shaft provided and close all guards before operating.
Step 12: Operation

Refer to the operator's manual for the start-up and run-in procedure.

Adjust the harvester suspension as recommended by the harvester manufacturer.

Follow a strict maintenance program to ensure the machine durability.

Refer to the operator's manual for storage and end of season procedure.
14 avril 2014
TM
harvesters
10