Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe 15346000 Mode D'emploi / Instructions De Montage

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Rate of flow by 0,3 MPa:
Factory preset:
Temperature adjustment:
Hot water temperature:
Thermal disinfection:
Thermal disinfection pursuant to process sheet DVGW
W 551 (≥ 70°C / > 3 min) must only be carried out by
qualified personnel. (see page 36)
The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 35)
After the installation, the output temperature of the
thermostat must be checked. A correction is necessary if
the temperature measured at the output differs from the
temperature set on the thermostat.
Dimensions (see page 38)
Spare parts (see page 38)
Cleaning (see page 39)
4
max. 1 MPa
0,1 - 0,5 MPa
(1 MPa = 10 bar = 147 PSI)
38°C ± 2K
30 - 45°C
max. 60°C
70°C / 4 min
Assembly basin mixer (see page 32)
Assembly Pillar Tap (see page 33)
English
Maintenance (see page 34)
• The mixer is equipped with check valves. The check
valves must be checked regularly according to
EN 806-5 in accordance with national or regional
regulations (at least once a year).
• To guarantee the smooth running of the thermostat, it
is necessary from time to time to turn the thermostat
from total hot to total cold.
1,6 MPa
12 l/min