Troubleshooting - Skil CR540601 Manuel D'utilisation

TROUBLESHOOTING

Problem
Tool does not start.
Blade does not
come up to speed.
Excessive vibration.
The blade does not
follow a straight line.
Cut binds, burns,
stalls motor when
ripping.
Blade slipping.
Cause
1. Battery pack is depleted.
2. Battery pack is not installed
properly.
3. Burned out switch.
1. Low battery.
1. Blade out of balance.
2. Workpiece not clamped or
supported properly.
1. Blade teeth are dull.
2. Foot is out of line or bent.
3. Blade is bent.
1. Dull blade with improper
tooth set.
2. Blade binds.
3. Improper workpiece
support.
1. Tool does not cut
workpiece.
Remedy
1. Charge the battery.
2. Confirm battery is properly secured
to the tool.
3. Have the switch replaced by an
Authorized SKIL Service Center or
Service Station.
1. Recharge the battery pack or use a
fully charged pack.
1. Discard blade and use a different
blade.
2. Clamp or support workpiece
properly according to this manual.
1. Change to a new blade.
2. Have the tool repaired by an
Authorized SKIL Service Center or
Service Station.
3. Change to a new blade.
1. Discard blade and use a different
blade.
2. Reassemble the blade and tighten
the washers according to this
manual.
3. Clamp or support workpiece
properly according to this manual.
1. Reassemble the blade and tighten
the washers according to this
manual.
23