Bimar S110TT Mode D'emploi page 10

Fax +32 030 9904733

• The appliance must not be positioned immediately under a socket.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
• All repairs should be made by a competent qualified electrician. Any faulty appliances should be
returned to this service.
ASSEMBLY
The wheel mounting brackets must be fixed to the underside (see up-down arrow on the label placed
on the appliance) and at the ends of the appliance to ensure stability; the wheels must be pointing
downwards and must be perfectly level. To assemble follow these instructions (refer to the figures
alongside):
1) Turn the radiator over and place it on the ground with the underside facing upwards. Insert the
brackets with the mounted wheels on the underside of the radiator by sliding them between the
elements at each end of the radiator (that is: between the first and second elements, and between
the last and second-to-last elements); block the crossbar using the "U" hooks provided.
2) Use the bolts provided to ensure that the crossbars are attached securely.
3) Check that the wheels are perfectly level.
Attention: the radiator must never be used without the wheels mounted.
Thanks to the wheels, the radiator does not heat the surface on which it rests, and air can circulate
naturally. The radiator can be moved easily on its wheels, using the folding handle at the top.
Attention: for the first use, leave it operaning at maximum power for at least two hours. During this
opearation, ventilate the room well to eliminate the "new" smell emanating from the appliance.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
Radiators with electro-mechanical controls: mod. S107.EU, mod. S109.EU, mod. S111.EU, and
mod. S109T.EU turbo.
The radiator can be adjusted as follows:
-Selector. Turn the relative knob (C) clockwise to select functions: 0= off, I= minimum, II= medium,
III= maximum (for values, see chart below).
- Room thermostat. Set (using relative knob B) the room temperature and start the radiator in
continuous mode until the set temperature is reached: if this drops, the radiator restarts for the time
necessary to re-establish the set value. If the knob is turned completely anti-clockwise, the radiator
remains off, if it is turned completely clockwise the maximum temperature is set; for intermediate
values the temperature increases as the knob is turned towards the Maximum position and vice versa.
The lamp is on when the heater is running, if it reaches the set temperature, the light goes out and
comes back as soon as it decreases.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
10 32
/
Assembly page 10/32