Control Panel - U.S. Products Solus 310R Directives D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONTROL PANEL

A
HEAT RECIRCULATION SWITCH:
order to pre-heat the cleaning solution -- up to 125 °F. NOTE: this switch must be turned OFF before priming and before
trying to clean.
B
HEAT RECIRCULATION LIGHT:
C
SEPARATE CIRCUIT LOCATOR LIGHT: When this light is on, it indicates that cord #2 (Identifi ed by the red "H" on the back of the
extractor.) is on a separate line from cord #1. Cord #2 supplies voltage to the heater allowing it to heat to the temperature range indicated by
the Heat Control dial (#1) on the switch plate.
D
BYPASS SWITCH: The bypass switch will illuminate when it is activated and will completely bypass the circuit locator system. Use this
system only when the circuit locator light will not turn on and you know each cord is on a separate circuit. NOTE: THE CIRCUIT BREAKER
CAN TRIP IF BOTH CORDS ARE ON THE SAME CIRCUIT AND THE BYPASS (heat) SWITCH IS TURNED ON.
E
HEAT MODE LIGHT: This light will only illuminate when the heater is heating and will turn off when it reaches operating temperature. During
normal operation, the "MODE" light will be on most of the time.
F
CARPET UPHOLSTERY SWITCH: This rocker switch activates a solenoid valve - when it is turned to Upholstery - that allows most of the
pump pressure to recirculate back to the Holding tank This allows you to clean delicate material at low psi (about 75 psi) When the switch
is set to Carpet, the pump operates without the solenoid and provides about 300 psi to the cleaning tool. The pump runs off of cord #1. The
pump spraying pressure will be observable at the pressure gauge. This switch does not light up.
G
PUMP ON/OFF SWITCH: This switch turns
the pump on and off. It will light up when it is
turned on
H
VACUUM SWITCH: This switch will illuminate
when the vacuum motors are on. The vacuum
motors run off of cord #1.
5/08
This switch will energize a solenoid that will pump heated water back into the holding tank in
This light will illuminate when the heated water is being pumped back into the holding tank.
A
B
F
INSTRUCTIONS FOR USE
56091035 - SOLUS
310R-PFR
®
ENGLISH - A
C
D
E
G
H
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Solus-310r-pfr

Table des Matières