U.S. Products Solus 310R Directives D'utilisation page 9

AUTO VACUUM SHUTOFF
When the recovery tank is full, the fl oat system will shut off the vacuum motor to prevent
the machine from overfl owing. The fl oat may not work in foam. Always use a defoamer to
prevent overfl ow. Once the vacuum motor shuts off, the Vacuum Switch (H) must be turned
off, the recovery tank emptied, and then the vacuum switch turned back on (up position) to
get the vacuum motor started again.
CAUTION:
Always make sure the fl oat is clean and travels freely before turning on the
machine. A fl oat that is stuck will cause the vacuum motor to suck in water,
resulting in vac motor damage.
PUMP PRESSURE:
Make sure the cleaning tool is spraying when adjusting the pressure, otherwise the pressure
reading will be inaccurate.
5
2
8
5/08
INSTRUCTIONS FOR USE
1
3
4
10
9
56091035 - SOLUS
A
B
F
310R-PFR
®
ENGLISH - A
C
D
E
G
H
9