Table des Matières
Publicité
– EN –
Instructions for Assembly
!
RISK!
Ensure that your working area is free of possible sources of danger,
for example don't leave any tools lying around. Always dispose packaging
material in such a way that it may not cause any danger. There is always a
risk of suffocation if children play with plastic bags!
!
WARNING!
Please note that there is always a danger of injury when wor-
king with tools or doing manual work. Therefore please be careful when as-
sembling this machine.
n
Ensure that you have received all the parts required (see check list) and
that they are undamaged. Should you have any cause for complaint, please
contact your KETTLER dealer.
n
Before assembling the equipment, study the drawings carefully and carry
out the operations in the order shown by the diagrams. The correct se-
quence is given in capital letters.
n
The equipment must be assembled with due care by an adult person. If in
Handling the equipment
n
Before using the equipment for exercise, check carefully to ensure that it
has been correctly assembled.
n
It is not recommended to use or store the apparatus in a damp room as this
may cause it to rust. Please ensure that no part of the machine comes in
contact with liquids (drinks, perspiration etc.). This may cause corrosion.
n
The machine is designed for use by adults and children should not be allo-
wed to play with it. Children at play behave unpredictably and dangerous
situations may occur for which the manufacturer cannot be held liable. If, in
spite of this, children are allowed to use the equipment, ensure that they
are instructed in its proper use and supervised accordingly.
n
A slight production of noise at the bearing of the centrifugal mass is due to
the construction and has no negative effect upon operation. Possibly oc-
curring noise during reverse pedalling result from engineering and are ab-
solutely safe.
n
To operate correctly, the pulse function requires a minimum voltage of 2,7
volts (only for computers working with batteries).
6
doubt call upon the help of a second person, if possible technically talen-
ted.
n
The fastening material required for each assembly step is shown in the dia-
gram inset. Use the fastening material exactly as instructed.
n
Bolt all the parts together loosely at first, and check that they have been as-
sembled correctly. Tighten the locknuts by hand until resistance is felt, then
use spanner to finally tighten nuts completely against resistance (locking
device). Then check that all screw connections have been tightened firmly.
Attention: once locknuts have been unscrewed they no longer function cor-
rectly (the locking device is destroyed), and must be replaced.
n
For technical reasons, we reserve the right to carry out preliminary assembly
work (e.g. addition of tubing plugs).
!
WARNING!
Protruding adjustment devices can endanger the movement
of the user.
n
Before beginning your first training session, familiarize yourself thoroughly
with all the functions and settings of the unit.
n
This manual can be downloaded from www.kettlersport.com.
n
Calibration of the device can only be carried out by the manufacturer.
n
This device is an RPM-independent / dependent training device, depense
on the Computer Modus.
n
The training device has a electromagnetic brake system.
Publicité
Table des Matières
