Upper Torso Control Device Option - SafeGuard Base XChange Seat Manuel D'utilisation Et D'entretien

Upper Torso Control Device Option

Seat must have LATCH and lap-shoulder belts to use upper torso control device. Upper tongues must be
installed to seat.
This system conforms to all applicable Federal Motor Vehicle Safety Standards.
WARNING! DEATH or SERIOUS INJURY can occur:
• Follow all instructions on the restraint and in this manual. Failure to follow the manufacturer's
warnings for proper use of this restraint system can result in serious injury or death.
• Use only with occupants who are at least 4 years old and weigh 40 pounds
(18 kg) or more and whose height is 40 inches (102 cm) or more.
• Never use the Upper Torso Control Device without the lap-shoulder seat belt restraint.
• Snugly adjust the belts provided with this restraint around the occupant.
1. Place the occupant in the bus seat with the occupant's back flat
against the back of the seat.
Secure lap-shoulder belt restraint
instructions on page 4 of this manual.
2. Fasten the buckle of the upper torso control device
attachment location at the top of the seat.
3. Position the first upper torso strap without the warning label
behind the occupant's shoulder and attach the connector to
the lower LATCH anchor
attachment point.
Listen for an audible click when the connector is attached.
Pull the free end of the first upper torso strap
remove any slack.
4. Position the second upper torso strap with the warning label
over the occupant's shoulder and attach the second connector
to the lower LATCH anchor located on the opposite side of
5
the occupant as shown.
connector is attached.
Position the shoulder height adjuster
control device at or just above the occupant's shoulder. Pull the
free end of the second upper torso strap
D
and tighten.
A snug strap should not allow any slack. It lies in a relatively
straight line without sagging. It does not press on the child's
flesh or push the child's body into an unnatural position.
on occupant per buckling
1
located directly below the upper
3
C
C
Listen for an audible click when the
D
A
to the
2
B
to tighten and
4
on the upper torso
6
to remove slack
7
9
1
Lap-Shoulder
Seat Belt
Restraint
A
B
Warning
Label
Pull to
tighten
Connector
C
6
5
7
D
2
Upper
Control
Device
Attachment
4
3