Yakima ForkLift Instructions De Montage page 4

Continued from previous page...
Remove wheeltray and rear clamp.
Slide wheeltray and rear
clamp back onto forks.
TIGHTEN DOWN KNOBS, close locking slider.
Install endcap.
Fully tighten the front knob.
1033615D-4/24
Flip orientation of rear clamp 180˚.
NOTE: You can flip the wheeltray or rear clamp
independently as needed. For instance if you
needed the buckle on the opposite side you
could flip the wheeltray as shown.
Fully tighten
the rear knob.
Close locking
slider.
Install vinyl
cap.