Publicité
Les langues disponibles
Les langues disponibles
Note: If using hood in recirculating mode skip these steps and turn to page 12.
Vertical Ducting
(7" Round)
1. Using a flat-head screwdriver, remove both the
rectangular and round knock-out plates located on
top of hood
Vertical Ducting
(3-1/4"x10" Rectangular)
1. Using a flat-head screwdriver, remove only the
rectangular section of the knock-out plate located
on top of hood.
Horizontal Ducting
(3-1/4"x10" Rectangular)
1. Using a flat-head screwdriver, remove the
rectangular knock-out plate located on back of
hood.
2. Secure 7" round collar to top of hood using
(6) M4 x 6 screws.
2. Secure 3-1/4" x 10" rectangular collar to top of
hood using (6) M4 x 6 screws.
2. Secure 3-1/4" x 10" rectangular collar to back of
hood using (6) M4 x 6 screws.
11
Publicité
