Frico Elztrip EZ200 Serie Mode D'emploi page 17

Thermal safety cut-out
If the installation is protected by means of a
thermal safety cut-out and it trips when the
appliance is connected, this may be due to
moisture in the heating element. When an
appliance containing heating element has
not been used for a long time and is stored
in a damp environment, moisture can enter
the element. This should not be seen as a
fault, but is simply rectified by connecting
the appliance without a thermal safety cut-
out so that the elements dry. The drying
time can vary from a few hours to a few days.
As a preventive measure the unit should
occasionally be run for a short time during
long operation pauses. At large installations,
there should be a division on several thermal
safety cut-outs.
Elztrip EZ 200
Safety
• During operation the surfaces of the unit
are hot!
• The unit must not be covered fully or
partially with flammable materials, as
covering can result in a risk of fire!
• This appliance is not intended for use
by children and persons with reduced
physical, sensory or mental capabilities,
or a lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by an individual responsible for
their safety. Children should be supervised
to ensure that they do not play with the
appliance.
GB
17