klover WAVE 90 Instructions D'utilisation page 44

CS.W110.IST-1 / Rev 1.3
MENU 03 – DATE AND TIME
Allows for setting the current day, date and time.
HOURS Clock
DAY Date
- Keys 1 and 2 (Increase and Decrease) allow you to modify the selected value.
- Key 4 (Set) selects the subsequent value.
- Key 5 (Esc) selects the previous value.
- Key 3 (ON/OFF) takes you back to the previous menu item.
MENU 04 – LANGUAGE
Allows you to select the dialogue language from the available choices (Italian, English, French, German and Spanish).
MENU 05 – SETTINGS
Allows you to adjust the different settings on the remote control.
The table below shows the settings and their meanings:
Menu
CARD BEEP
DISPLAY ILLUMINATION
DISPLAY ON
DISPLAY BRIGHTNESS
DISPLAY CONTRAST
KEY BEEP
* The values set affect the life of the batteries fitted in the remote control.
MENU 06 – INITIAL LOAD
Enables pellet pre-loading for 90" when the appliance is switched off and cooled down. Start the function with key 1 (Increase) and stop with key 3
(On/Off). This may be useful if the appliance is switched on after the tank has been completely emptied, or when it is filled for the first time. Warning:
once the operation has been completed, before switching on the appliance you should remove any accumulation of pellets deposited inside
the ash drawer.
MENU 07 – FIREPLACE STATUS
Allows for viewing the current status of the appliance, by showing the operating conditions of the various devices connected to it. Several pages are
displayed in succession. The data is reserved for Technical assistance Centre.
The table below shows the various devices and their meanings:
Display
L04-270218 (example)
ARIA 1.0 (example)
F.GS.T
R.TMP.
R.TMP 1
DAY
Meaning
Enables/disables the beep sound made by the power card
Regulates the duration of the display illumination
Regulates the duration of the display activation
Enables/disables display illumination
Regulates the display contrast
Enables/disables the beep sound made each time a key on the remote control is
pressed
Meaning
Firmware code loaded in the control unit.
Firmware code loaded in the remote control.
Indicates the temperature read by the sensor inside the combustion chamber.
Indicates the room temperature as measured by the sensor inside the remote control.
If a temperature sensor is connected, this indicates the temperature in ducted room 1 measured by the same.
If a room thermostat is connected, this indicates the status of the same
(OFF = R.T. contact OPEN = Thermostat not in demand)
(ON = R.T. contact CLOSED = Thermostat in demand)
16
ENGLISH
MINUTES Clock
MONTH Date
YEAR Date
Values that can be set *
ON – OFF
2 / 10 secs
15 / 60 secs – ON
ON – OFF
15 / 60 #
ON – OFF