Support Panel; Power Status - klover WAVE 90 Instructions D'utilisation

CS.W110.IST-1 / Rev 1.3

Support panel

Led 3 – POWER STATUS
Led 2 – POWER STATUS
The table explains how the keys on the support panel work.
Key Description
1 ON/OFF
2 POWER
The table explains how the LEDs on the support panel work.
LED Description
1 ON/OFF
2 and 3

POWER STATUS

4 RECEPTION
5 ALARM
6 WIFI
The support panel allows you to control basic functions governing the operation of the appliance in the absence of the remote control.
The following operations can be carried out:
- SWITCH ON/OFF: holding key 1 (On/Off) down for 2 seconds
- MODIFY OPERATING POWER: each press of key 2 (Power) varies the operating power by selecting one of the three available power settings
(1, 3 or 5). With the help of LEDs 2 and 3 (Power status) you can check the set power setting
Led 4 – RECEPTION
Led 1 – ON/OFF
Mode
Working..
Off..
In alarm block..
Each press...
With long press 6 seconds ...
Status
Off
Flashing
On
Led 2 On, Led 3 Off
Led 2 On, Led 3 On
Led 2 Off, Led 3 On
On
On
Off
Slow flashing
Fast flashing
On
Action
Switches the appliance off when pressed for 2 seconds.
Switches the appliance on when pressed for 2 seconds.
Releases the alarm.
Modifies the operating power "SET POWER", choosing from the 3 available power
settings (1, 3 or 5).
It allows the WiFi module to enter WPS mode to facilitate connection to the WiFi
network of the home modem (it is also necessary to hold down the WPS button of
the modem, according to its characteristics).
Action
The appliance is off.
The appliance is shutting down.
The appliance is on.
Power set to setting 1.
Power set to setting 3.
Power set to setting 5.
On when the card receives a signal from the remote control.
The appliance is in alarm.
The appliance is not connected to a Wifi network.
The WiFi module is in Access Point mode (waiting for connection to the network).
The WiFi module is in WPS (signal search) mode.
The appliance is connected to a Wifi network.
12
Led 6 – WIFI
Led 5 – ALARM
Key 2 – POWER / WPS
Serial Connection for Remote Control
Key 1 – ON/OFF
(see LED table).
ENGLISH