AneX m/type PRO Manuel D'entretien page 7

PRE-USE PROCEDURES
Stroller assembling/disassembling
Take the stroller's frame out of the box and
place it horizontally on the floor (Fig. 1). Release
the safety catch for accidental unfolding (Fig. 2),
and while holding the handle, pull up actively to
ensure that the system is locked correctly (you
should hear a characteristic sound) (Fig. 3). Press
the button on the right lever arm of the frame
to fold the frame. After that, simultaneously
pull the lever arms on both sides of the frame
all the way in (Fig. 4). Next, slightly push the
frame down to restore it to the initial position
it had at the moment of unfolding the stroller
(Fig. 1). For easy and efficient use, through the
same sequence of operations, the frame can
be folded together with the seat without taking
the seat unit off the frame. This is possible if
the seat is facing toward the direction of travel,
with the footrest beingin the lowest position,
the hood folded, and the stroller's handle being
turned down (Fig. 5).
Handle height adjustment
Simultaneously press the round buttons,
arranged parallel on both sides of the handle.
Set a handle height that is comfortable for
you (Fig. 6).
Installation and removal
of rear wheels
Before installing a wheel, insert the axis into
the respective spot at the bottom of the frame
(until you hear a distinctive sound) (Fig. 7).
In order to set the wheel on the axis, pull it
off slightly until you hear a distinctive click
(Fig. 8). The wheel can be removed both with
and without the axis. Press the button at the
bottom of the frame to remove the wheel with
the axis (Fig. 9). To remove the wheel without
the axis, push the middle part of the wheel
and drag it along the axis until it comes off
completely (Fig. 10).
Installation/removal of the front
swivel wheels/lock
The stroller's frame is equipped with two front
swivel wheels that can rotate 360° around
the vertical axis. To fit the front wheels, the
wheel axle must be installed in the appropriate
position on the frame and pushed up until the
system is fixed (Fig. 11). In order to remove the
wheel, press the button, and the wheel will be
automatically disconnected (Fig. 12). If you
need to fix the swivel wheel system, press the
button above the wheel (Fig. 13). Additionally,
for convenience and efficiency, you can lock
the wheels by pressing the button by hand
as well as by foot.
Brake
The stroller is equipped with brakes that lock
the rear wheels. Push down on the pedal
that locks the rear wheels in order to stop
the stroller (Fig. 14). Turn back the pedal
to the starting position to continue moving.
Shock absorption
The stroller has a spring type shock absorption
system and regulated shock absorption on the
frame to improve your baby's comfort (Fig. 15).
To adjust the shock absorption system on the
EN
7