English - Celestron TRAILSEEKER Mode D'emploi

removing the FlUid pan head
The TrailSeeker tripod ships with the fluid pan
head attached to the tripod legs, but it can be
removed. The head of the tripod is threaded
onto the tripod legs and held in place with three
set screws. To remove the head, loosen the
set screws located under the center column
with the included hex key. With the pan/tilt
tension knob tightened, turn the tripod head
counterclockwise until it unthreads from the
center column.
Note:
If the tripod head loosens from the tripod legs while panning,
tighten the set screws under the center column.
Fig. 9
I ENGLISH
8