Standby Mode; Turning Off The Device - vigo TURBO EMI 750 Mode D'emploi

EN
person does not apply any pressure on the device), it will switch to stand-by position
and stop the warming. This feature decreases the energy consumption significantly in
case of a typical use.
Stand-by Mode
When no presence is detected (i.e. no pressure applied on the surface of the device) the
device at the end of the running level shifts to stand-by mode where it runs on minimal
power for four hours only to retain surface temperature. At the end of this duration,
heating is shut down completely. If there is contact on the surface before the end of the
four-hour duration, the device resumes operation at the level running before stand-by,
the aim of which is to rprevent immediate cool-down of the device as well as to ensure
flow of warm air upon contact. The fan does not run on stand-by mode and only the
contact surface of the heater warms up.
If the device is not run with the Turbo key but using the '+' key of the remote
controller, or directly from the dashboard using the the on/off key to initiate
the Turbo mode, then the device will run on this mode for a duration of 10
minutes and before switching to stand by.
Running the Device Continuously (at Turbo Timer Mode)
In cases when you wish to heat the room or the device surface faster, turn 'Turbo Timer'
mode on using the remote controller to run the device without interruption for four
hours. At the end of the four-hour period the Turbo Timer mode will end, activating the
presence detector. When you touch on the surface of the device, it runs for 10 minutes
at max. And shift to stand by mode. To resume turbo mode, regardles of the current
mode (including stand-by) just press the Turbo Timer key on the remote controller. To
exit Turbo Timer mode, use the '-' key to switch to levels 3, 2, 1 and turn off via 'power'
key.

Turning Off the Device

Turbo Foot Warmer can be turned off in 3 ways:
1- The warmer turns off automatically within 30 minutes when no pressure is applied
on the device.
2- It turns off when POWER button on the remote control is pressed.
3- It turns off when On/Off button on the device is pressed for a long time.
Attention: Unless the device is not plugged out, the stand-by light on the device will
be on.
23