Oad Troubleshooting - cascade corporation D Serie Manuel De L'opérateur

L
OAdiNG WITH ADJUSTABLE BUMPER OPTION
VERTiCAl PiCKuP
A) Close arms to approximate
roll diameter
B) Drive forward touching
bumper to roll
RC2169.eps
L

OAd TROuBlESHOOTiNG

iF lOAd iS SliPPiNG:


Re-clamp load,
contact pads
centered on and
parallel to roll, roll
against bumper
(if equipped)
6083498 EN
5-10 cm
C) Clamp with long arm
Check weight
of roll is within
capacity range of
Clamp
(See nameplate)
BilGE PiCKuP
A) Close arms to approximate
roll diameter
3-4°
B) Tilt, drive forward touching bumper to roll
Check hydraulic supply pressure and
clamp force, see following:
3
• Appropriate Clamp Service Manual
• Clamp Force indicator
Operator Guide 214750
• Establish Clamp Force TB 284
Check condition and
type of contact pad
surface, change or
replace if necessary
RC2166.eps
C) Clamp with
long arm
RC0074.eps
4