Important; Care And Cleaning - Thinkkitchen NIAGARA Mode D'emploi & Instructions D'installation

indicate that the Kettle is in the boil cycle. Once the water has boiled,
the On/Off Switch will move to the OFF ('O') position and the light will
go out. IMPORTANT: The kettle shuts off automatically only after the
boiling cycle is complete. If the kettle is removed from the base before
the boiling cycle is complete then it will begin to heat as soon as it is
put back on the base. To turn the kettle off before the boiling cycle is
complete, press the On/Off Switch to the OFF ('O') position.
7. The Lid should not be opened when the Kettle is hot.
8. If you want to use the Kettle again, allow the thermal safety switch to
cool down for 15 to 20 seconds then depress the On/Off Switch to the
ON ('I') position. If the On/Off Switch does not remain in the ON ('I')
position, the water is hot enough to use without reheating.
9. Only grip the Kettle by the Handle as all other surfaces will be hot.
10. Return the Kettle to the Base or a heat resistant surface after use.
11. IMPORTANT: If the Kettle is accidently switched on when empty, the
thermostat will automatically cycle on and off to prevent the Kettle
from overheating. If this situation occurs, press the On/Off switch to
the OFF ('O') position and unplug the Kettle immediately. Let the Ket-
tle cool before refilling.
12. DISCONNECT the Power Cord from the wall outlet when not in use.

CARE AND CLEANING

1. All servicing, other than cleaning, should be performed by an autho-
rized service representative. See Warranty section.
2. Unplug the Base from the wall outlet. Empty the Kettle and allow it to
cool before cleaning.
Exterior
• Use a soft, damp cloth to clean the exterior.
• DO NOT use abrasive cleaners. Dry exterior thoroughly before use.
• DO NOT immerse kettle or power base in water or other liquid.