LEMAN MOR375 Manuel D'utilisation page 45

ADDITIONAL SAFETY RULES FOR HOLLOW
CHISEL MORTISERS
1. DO NOT OPERATE THIS MACHINE until it is assembled and installed according to the instructions.
2. OBTAIN ADVICE FROM YOUR SUPERVISOR, instructor, or another qualified person if you are
not familiar with the operation of this machine.
3. FOLLOW ALL WIRING CODES and recommended electrical connections.
4. MAKE CERTAIN the machine is fastened to a supporting surface to prevent it from tipping over
during operation.
5. NEVER turn the mortiser " ON" before clearing the table of all objects (tools, scrap pieces, etc.).
6. ALWAYS keep hands, fingers and hair away from the rotating bit.
7. DO NOT attempt to mortise material that does not have a flat surface, unless a suitable support is
used.
8. ALWAYS position holddown directly over workpiece to prevent workpiece from lifting during operation.
9. ALWAYS support workpiece securely against fence to prevent rotation.
10. BE SURE drill bit is sharp, not damaged, and properly secured in the chuck before operation.
11. MAKE SURE chuck key is removed before starting machine.
12. NEVER turn on the power with the drill bit or chisel contacting the workpiece.
13. NEVER perform layout, assembly, or set-up work on the table while the mortiser is operating.
14. ADJUST the depth stop to avoid drilling into the table.
15. ALWAYS turn off the power before removing scrap pieces from the table.
16. SHUT-OFF the power, remove the drill bit and chisel, and clean the table before leaving the machine.
17. FOR YOUR OWN SAFETY – Don't wear gloves when operating the machine.
18. SHOULD any part of your tool be missing, damaged, or fail in any way, or any electrical component
fail to perform properly, shut off switch and remove plug from power supply outlet. Replace missing,
damaged, or failed parts before resuming operation.
19. THE USE of attachments and accessories not recommended by Delta may result in the risk of
injuries.
20. TURN THE MACHINE " OFF" AND DISCONNECT THE MACHINE from the power source before
installing or removing accessories, before adjusting or changing set-ups, or when making repairs.
MS3816 Hollow Chisel Mortiser
３
EN
V.03 01-03-2008