General Safety Rules - LEMAN MOR375 Manuel D'utilisation

GENERAL SAFETY RULES

Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all
machinery, there are certain hazards involved with the operation of the product. Using the machine with
respect and caution will considerably lessen the possibility of personal injury. However, if normal safety
precautions are overlooked or ignored, personal injury to the operator may result. Safety equipment such
as guards, push sticks, hold-downs, featherboards, goggles, dust masks and hearing protection can
reduce your potential for injury. But even the best guard will not make up for poor judgment, carelessness
or inattention. Always use common sense and exercise caution in the workshop. If a procedure feels
dangerous, do not try it. Figure out an alternative procedure that feels safer. REMEMBER: Your personal
safety is your responsibility.
This machine was designed for certain applications only. We strongly recommend that this machine
cannot be modified and/or used for any application other than that for which it was designed. If you have
any questions relative to a particular application, DO NOT use the machine until you have first contacted
your local dealer to determine if it can or should be performed on the product.
WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY
FOR YOUR OWN SAFETY, READ INSTRUCTION MANUAL BEFORE OPERATING THE TOOL.
1.
Learn the tool's application and limitations as well as the specific hazards peculiar to it.
KEEP GUARDS IN PLACE and in working order.
2.
ALWAYS WEAR EYE PROTECTION. Wear safety glasses. Everyday eyeglasses only have impact
3.
resistant lenses; they are not safety glasses. Also use face or dust mask if cutting operation is dusty.
REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and
4.
adjusting wrenches are removed from tool before turning it "on".
KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
5.
DO NOT USE IN DANGEROUS ENVIRONMENT. Do not use power tools in damp or wet locations,
6.
or expose them to rain. Keep work area well-lighted.
KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept a safe distance
7.
from work area.
MAKE WORKSHOP CHILDPROOF – with padlocks, master switches, or by removing starter keys.
8.
DO NOT FORCE TOOL. It will do the job better and be safer at the rate for which it was designed.
9.
10. USE RIGHT TOOL. Do not force tool or attachment to do a job for which it was not designed.
11. WEAR PROPER APPAREL. No loose clothing, gloves, neckties, rings, bracelets, or other jewelry to
get caught in moving parts. Nonslip footwear is recommended. Wear protective hair covering to
contain long hair.
12. SECURE WORK. Use clamps or a vise to hold work when practical. It is safer than using your hand
and frees both hands to operate tool.
13. DO NOT OVERREACH. Keep proper footing and balance at all times.
14. MAINTAIN TOOLS IN TOP CONDITION. Keep tools sharp and clean for best and safest
MS3816 Hollow Chisel Mortiser
１
EN
V.03 01-03-2008