DIAMONDBACK FITNESS Response R8c Manuel Du Propriétaire page 8

Remove the four (4) hex fixing bolts
(F1) and flat washers (F2) from the
seat slide assembly. Align holes in
the seat back (G) mounting plate
with the holes in the seat slide and
reinstall the four (4) sets of F1 & F2.
Align the fixing holes in the
underside of seat base (L) with
holes in the two square tubes
welded to the seat slide assembly.
Install the four (4) sets of flat
washers (K1) and hex bolts (K2)
through the underside of the holes
in the square tubes and into the
seat base.
Remove the two (2) hex bolts (M) from the console mast (T). Align the two
holes in the bottle cage (N1) with the holes in the console mast and tighten
with the Phillips screwdriver provided. Slide the bottle (N2) into the cage.
Remove the five (5) hex bolts (U1), four (4) flat washers (U2) and one (1)
curved washer (U3) from the console mast (T) and set aside.
Slide the console mast cover (FF) onto the console mast.
While supporting the console mast, join plugs (P) and (Q1) and (R) with (S1).
Slide the console mast (T) over the receiver on the main frame taking care not
to pinch the wires as they are tucked into the frame. Re-install parts U1, U2 &
U3 only into the three lower holes and tighten.
Slide the console mast cover (FF) downward and snap into place.
Re-install the two (2) bolts (U1) and washers (U2) into the upper holes and
tighten.
8
T
U
3
N
1
U
2
L
M
N
2
U
1
S
1
R
Q
1
FF K
1
P
K
KK
2
2
W W W W W
5 4 2 1
3
V
G
F
2
F
1
Remove the four (4) sets of flat washers
(H1) and hex bolts (H2) from the rear
mounting plate of the seat back (G). Align
the mounting holes of the rear handlebar
(J) with the seat back mounting plate holes,
and reinstall parts H1 & H2.
Plug the loose end of the heart rate wire
pigtail (GG) into the jack located in the
center of the fixing bolts on the rear
handlebar (J).
While supporting the front handlebar (V),
install handlebar clamp assembly W1,
W2, W3, W4 & W5 as per the diagram.
Determine the preferred angle of the bar
prior to tightening the hardware completely.
3
G
GG
J
H
1
H
2