Rocky Mountain INSTINCT CARBON Serie Mode D'emploi page 17

Instinct Carbon Platform Manual
REPLACING/INSTALLING DROPPER POST HOUSING
1. Remove drive side head tube port cover.
2. If replacing the old housing, cut a new piece to the same
length. If you don't have the old piece, approximate the length
required and cut a slightly longer portion.
3. Beginning from the head tube port, begin feeding the
housing into the bottom housing opening. Push the housing
forward until it comes out at the seat tube.
4. Complete the dropper post installation as per the dropper
post manufacturer's instructions.
5. Once the seat post is correctly installed, re-install the
headtube port.
1.
3.
5.
Cable routing how to 17