Philips Philishave 1000 Serie Mode D'emploi page 8

ENGLISH
8
To use the hair clipper connected to the mains: switch the hair
clipper off, connect it to the mains and wait a few seconds before
switching it on.
Using the appliance
Also see the quick-start CD-ROM.
Clipping with comb attachment
The hair length after cutting is indicated in millimetres on the
result indicator (fig. 5).
The hair length after cutting is only visible when one of the
combs is attached. Use the small comb for a length of 3-21 mm
and use the large comb for a length of 23-41 mm.
1 Slide the comb attachment into the guiding grooves of the
appliance ('click') (fig. 6).
Make sure that the arms of the comb attachment have been properly
slid into the grooves on both sides.
2 Set the comb to the desired hair length by turning the length lock
(fig. 7).
Small comb
hair length
3 mm
6 mm
9 mm
12 mm
15 mm
18 mm
21 mm
3 Switch the appliance on (fig. 8).
Choose the appropriate hair cutting method on the quick-start CD-ROM.
Large comb
hair length
23 mm
26 mm
29 mm
32 mm
35 mm
38 mm
41 mm