Realwear HMT-1Z1 Mode D'emploi page 5

Using the HMT-1Z1 with a Hard Hat
To get hard hat clips, visit shop.realwear.com.
1. Hook the Hard Hat Clips into the HMT-1Z1 band and snap them into place.
2. Slide the clips into the hard hat accessory slots; the HMT-1Z1 band should sit
outside of the hard hat's harness.
3. Put on the hard hat and if applicable, tighten until secure and comfortable.
4. To remove the HMT-1Z1 from the hard hat, pinch the clip ngers and push the clip out of
the hard hat slots.
Using the HMT-1Z1 without a Hard Hat
Attaching the Rear Pad
The Rear Pad snaps
onto the HMT-1Z1's
rear band; align the
openings on the Rear
Pad to the pegs on
the HMT-1Z1's rear
band, and snap into
place.
During operation, remove the Rear Pad to view
intrinsically safe regulatory information.
A B C D E A F B
Attaching the Head Strap
Insert the end of the
strap into the inside
slot on both sides
of the HMT-1Z1 as
shown. Fold the end
back on itself and
secure using the
velcro patch.
G C H D I E
A
J F G H
B C D