Dell Latitude X300 Information Produit page 25

When the boot device list appears, highlight Diagnostics and press <Enter>.
5
The computer runs the Pre-boot System Assessment, a series of initial tests of your
system board, keyboard, hard drive, and display.
• During the assessment, answer any questions that appear.
• If a failure is detected, the computer stops and beeps. To stop the assessment
and restart the computer, press <N>; to continue to the next test, press <Y>;
to retest the component that failed, press <R>.
• If failures are detected during the Pre-boot System Assessment, write down the
error code(s) and contact Dell before continuing on to the Dell Diagnostics.
If the Pre-boot System Assessment completes successfully, you receive the message
Booting Dell Diagnostic Utility Partition. Press any key to
.
continue
Press any key to start the Dell Diagnostics from the diagnostics utility partition on
6
your hard drive.
When the Dell Diagnostics Main Menu appears, select the test you want to run.
7
Dell Diagnostics Main Menu
After the Dell Diagnostics loads and the Main Menu screen appears, click the button
1
for the option you want.
Option
Express Test
Extended Test
Custom Test
Symptom Tree
Function
Performs a quick test of devices. This test typically
takes 10 to 20 minutes and requires no interaction
on your part. Run Express Test first to increase the
possibility of tracing the problem quickly.
Performs a thorough check of devices. This test
typically takes an hour or more and requires you
to answer questions periodically.
Tests a specific device. You can customize the tests
you want to run.
Lists the most common symptoms encountered
and allows you to select a test based on the symptom
of the problem you are having.
Sy s tem I nf o r m a ti on G u id e
23