System Monitoring; General; Fronius Datamanager During The Night Or When The Available Dc Voltage Is Insufficient; Starting For The First Time - Fronius Primo 3.0-1 Instructions De Service

System monitoring

General

The inverter is fitted with the WLAN-enabled system monitoring Fronius
Datamanager 2.0 as standard.
The following functions are included with the system monitoring:
-
-
-
-
-
-
-
-
-
Further information on Fronius Datamanager 2.0 can be found online in the
Fronius Datamanager 2.0 Operating Instructions.
Fronius
The Night Mode parameter under "Display Settings" in the Setup menu is preset
Datamanager to OFF in the factory.
during the night For this reason the Fronius Datamanager cannot be accessed during the night or
or when the when the available DC voltage is insufficient.
available DC
voltage is insuf-
To nevertheless activate the Fronius Datamanager, switch the inverter off and on
ficient again at the mains and press any function button on the inverter display within
90 seconds.
See also the chapters on "Menu items in the Setup menu", "Display settings"
(Night Mode).
Starting for the
Setting up the Fronius Datamanager 2.0 for the first time is made considerably
first time easier with the Fronius Solar.web app. The Fronius Solar.web app is available in
the respective app stores.
When starting Fronius Datamanager 2.0 for the first time,
-
-
16
Dedicated web page displaying current data and a wide range of settings
Ability to connect to Fronius Solar.web using WLAN or LAN
Automatic sending of service messages by SMS or e-mail in the event of a
fault
Option of controlling the inverter by specifying power limit values, minimum
or maximum running times or target running times
Control of the inverter via Modbus (TCP / RTU)
Ability to assign control priorities
Ability to control the inverter by means of connected meters (Fronius Smart
Meter)
Ability to control the inverter via a ripple control signal receiver (e.g. by spe-
cifying the reactive power or effective power)
Dynamic power reduction, taking self-consumption into account
the Fronius Datamanager 2.0 plug-in card must be installed in the inverter,
or
there must be a Fronius Datamanager Box 2.0 in the Fronius Solar Net ring.