Overview - Resol Heizstab Mode D'emploi

1

Overview

The electric immersion heater is designed for installation into a hot water store
and can be used for heating as well as for DHW heating. In combination with the
DeltaTherm PV it converts excess PV current into thermal energy.
®
• Single-phase electric immersion heater up to 3 kW, variable and grid
compliant
• Thermal cut-out at 95 °C
• Use of excess current for heating a water store
Technical data
Maximum temperature seal pipe end: 120 °C
Maximum temperature pipe surface: 120 °C
Operating voltage: 230 V~
Power: 3 kW
Immersion depth: 250 mm
Protection type: IP 54
Unheated length: 95 mm
Thermal cut-out: 95 °C
Maximum operating pressure: 10 bar
Material: Heating element: 2.4858, INCOLOY
Protection class: I
Medium: water
® 825
Contents
1 Overview..........................................................................................11
2 Installation .......................................................................................12
2.1 Mounting ..................................................................................................................12
2.2 Electrical connection .............................................................................................12
3 Commissioning ...............................................................................13
4 Safety devices ..................................................................................13
5 Maintenance ....................................................................................13
6 Accessories ......................................................................................14
11