RENINSHAW PSU3 Manuel D'installation Et D'utilisation page 8

1-2
EC DECLARATION OF CONFORMITY
Renishaw plc declares that the product:
Name Description
PSU3 24 Vdc power supply unit
has been manufactured in conformity with the following standards:
BS EN 61326: 1998/ Electrical equipment for measurement,
A1:1998/A2:2001 control and laboratory use - EMC
requirements. Immunity to annex A -
industrial locations. Emissions to class A
(non-domestic) limits.
BS EN 61010-1: 2001 Safety requirements for electrical
equipment for measurement, control and
laboratory use.
Part 1: General requirements.
and that it complies with the requirements of the following
directives (as amended):
89/336/EEC Electromagnetic compatibility
73/23/EEC Low voltage
The above information is summarised from the full EC Declaration
of Conformity. A copy is available from Renishaw on request.
Preliminary information
Information to user (FCC Section 15.105)
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used
in accordance with this installation guide, may cause harmful
interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in
which case you will be required to correct the interference at your
own expense.
Information to user (FCC Section 15.21)
The user is cautioned that any changes or modifications not ex-
pressly approved by Renishaw plc or authorised representative
could void the user's authority to operate the equipment.
FCC