Publicité
13
REINSTALL THE TOWERS AND BARS.
15
INSTALL THE END CAPS.
Press the end caps into
place using caution
so that the tabs are
seated properly.
16
TEST THE INSTALLATION.
Grab the
crossbar near
each tower and
tug at it in all
directions to
make sure it's
secure. Retighten
your towers or
landing pads if
necessary.
Instruction #1036022A-Page 6 of 10
14
CLOSE THE COVERS.
Close the
covers and
use the key
to lock your
towers.
2X
1. Unlock and open the SkyLine tower covers.
2. Carefully lift to remove the tower and
crossbar assemblies.
3. Use the 5 mm wrench to remove the
Landing Pad hardware.
4. Remove the Landing Pads.
NOTE: If you elect
to leave the Landing
Pads on your truck,
follow REMOVAL
steps 1 and 2 then
install the covers
provided in this kit.
REMOVAL
4X
4X
4X
Publicité
