Yakima TRACKS Instructions De Montage

TRACKS
REFER TO THE
TRACK FIT SHEET
for track placement
and important details
about your vehicle!
DO NOT DRILL DEEPER THAN 1/4". Use a drill
stop to prevent drilling through vehicle's interior
liner. If you do not have a stop, use tape and
mark bit 1/4" from tip.
Attach Plusnut®
and washer
to tool
Attach
as shown.
soft rubber
washers
onto
Plusnuts®.
Note: Washer
should be flat
against
Plusnut® head.
1030988E-1/4
TOOLS REQUIRED:
adjustable end wrench
1/2" wrench
1/8" Allen wrench
center punch
hammer
electric drill
1/8" drill bit
9/32" drill bit
touch-up paint
Align tracks and position
track ends according to
information in the
track fit sheet.
Drill
1/8"
pilot hole
Wear goggles
when drilling!
Attach nut
with washer
onto
Plusnut®
tool.
Outline rear hole through track.
Track base is loose and can slide.
Be sure it is aligned to track.
Drill 9/32" hole
Tighten nut on tool using
Set
1/2" wrench and adjustable
into hole.
end or 7/16" wrench.
Tighten only until
there is a noticeable
increase in the force.
ATTENTION INSTALLERS:
If you will be installing tracks on several vehicles,
call for information on industrial grade installation tools.
YAKIMA CUSTOMER SERVICE: 888-925-4621
Remove track.
Carefully blow
away debris
Remove flaring tool:
Use adjustable end \wrench
to unscrew post from Plusnut®.
Reassemble tool
for next Plusnut®.
I N S T R U C T I O N P A R T # 1 0 3 0 9 8 8 R E V. E
Punch center of mark
for drilling.
Seal edges
of hole with
enamel base
paint.
Allow to dry.