Yakima TRACKS Instructions De Montage page 2

Place track on roof
aligning hole.
Center punch, pilot, drill, clear, seal, install Plusnut® INTO FRONT HOLE.
(Steps 4 through 10)
Never
punch or drill
through track.
READ YOUR TRACK FIT SHEET
for your vehicle's
correct drilling points.
Center punch, pilot, drill, clear, seal, install
Plusnuts® (Steps 4 through 10).
Slide nut plates from your tower kit into
track (2 per tower / 4 per track).
Attach end caps before attaching tracks to roof.
This product is covered by YAKIMA's
"Love It Till You Leave It" Limited Lifetime Warranty
1030988E-2/4
Outline front hole.
Install bolt
loosely.
Carefully mark and drill only the correct
With track on car, attach bolts and hard washers
through track into Plusnuts®.
Do not use washers
on bolts at each end
of tracks.
Before marking—
REFER TO
TRACK FIT SHEET
for track alignment.
holes for your specific vehicle.
Apply a generous amount of silicone
sealant into the Plusnut® opening.
NOTE: There may be extra Plusnuts®
because not all holes in the tracks will be used.
To obtain a copy of this warranty, go online to www.yakima.com
or email us at yakwarranty@yakima.com or call (888) 925-4621
Pivot the track
to install front Plusnut®
Loosen bolt if necessary.
Install front bolt
through track into
Plusnut®.
Loosen bolts and remove track
from vehicle.
WARNING: Direct contact of uncured sealant irritates eyes
and may irritate skin. Over exposure to vapor may irritate
eyes, nose and throat. Avoid eye and skin contact. Use with
adequate ventilation. Do not handle contact lenses with
sealant on hands. In case of eye contact, flush with water
for 15 minutes. Obtain medical attention. In case of skin
contact, remove from skin and flush with water. Sealant
releases acetic acid (vinegar-like odor) during cure.
Congratulations!
SECOND
Install your towers
TRACK
& mount your
INSTALLATION:
accessories for your
Repeat entire
next sporting
instruction
adventure!
beginning at