Assa Abloy EMTEK LISCIO Guide D'installation page 11

Programming Features
Once App is setup and you have logged into app you will be on the
Home screen – from here you can:
Select Users – you can add, edit and
A
delete users
1. To add user – select + New, enter
Name and enter user code (factory set
at 4 digits)
2. To edit user – select user to edit, user
information will be shown, select Edit,
edit as needed, select Update
3. To delete user – select user to edit,
user information will be shown, select
Edit, select X Delete
4. You must communicate changes to
lock before they are recognized at the
lock – see Transfer below (B)
Select Transfer – you can send data/
B
setting changes to the lock, view lock
activity or get data/settings from the lock
1. Sending data to Lock – to
communicate any user adds, edits or
deletes along and any settings changes
2. Viewing lock activity – lock activity on
app is from last update, you will need to
select Get new lock activity to view the
latest activity
3. Getting data from Lock – to
communicate latest user and setting
data from the lock to the app
Select Setting – you can customize
C
some of the lock and app features
1. From the settings screen you can
edit the noted settings, scrolling down
is Advanced Settings
Select Logoff when you are done or when
D
you want to program a different lock.
Battery Status – when BT
E
communications are successful, an
"Operation Complete" screen gives
you a battery status.
1. "Good" means battery has the power
to operate lock and BT communications.
2. "Low" means battery still has power
to operate lock and BT communications
but should be replaced. Lock LED
shows 4 amber flashes and 4 beeps.
3. "Blackout" means the battery can no
longer operate lock and battery must be
replaced. Lock LED shows 6 red flashes
and 6 beeps
4. Replacement battery should be a high
quality 9 volt alkaline battery. Battery is
located behind the interior trim plate.
EN
11