Warranty And Disclaimer - Halosense SaltAir ST-UV01 Manuel Du Propriétaire

TROUBLE
The power light is blinking and
the DEVICE does not work
Abnormal noise
Salt crystallized around midline
or slowly leakage
Water leakage from DEVICE

WARRANTY AND DISCLAIMER

SaltAir comes with one year manufacturer warranty. Halosense Inc. repairs or replaces equipment that proves to
UV
be defective during the warranty period. Warranty includes parts and labor.
Manufacturer will provide circuit diagrams, component part lists, descriptions, calibration instructions to assist
service in parts repair.
The warranty provided herein does not cover equipment subjected to abuse, misuse, accident, alteration, neglect,
or unauthorized repair or installation. Halosense Inc determines if the cause of defect is due to a manufacturing
malfunction or customer misuse. Note: The device has to be used only with our provided rock salt for the warranty to
be in effect. Using a different kind of salt will void the warranty, as it can affect negatively the lifetime of the device and
the health results!
EXCEPT AS SPECIFIED HEREIN, HALOSENSE INC. MAKES NO WARRANTIES, EXPRESSED OR IMPLIED,
AND SPECIFICALLY DISCLAIMS ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE. CUSTOMER'S RIGHT TO RECOVER DAMAGES CAUSED BY FAULT OR NEGLIGENCE ON THE
PART OF HALOSENSE INC. WILL BE LIMITED TO THE AMOUNT PAID BY THE CUSTOMER. HALOSENSE INC.
WILL NOT BE LIABLE FOR DAMAGES RESULTING FROM LOSS OF DATA, PROFITS, USE OF PRODUCTS, OR
INCIDENTAL AND CONSEQUENTIAL DAMAGES.
Symbols that we used here:
Signs
International Recycling Symbol shows that these materials can be changed into new products to
prevent waste of potential useful materials.
Symbol for CE Mark. This symbol certifies that a product has met European Union consumer safety,
health or environmental requirements.
Where you see either symbol on any of our electrical products, batteries or packaging, it indicates
that the relevant electrical product or battery should not be disposed of as general household waste
in Europe. To ensure the correct waste treatment of the product and battery, please dispose them
in accordance with any applicable local laws or requirements for disposal of electrical
equipment/batteries.
In so doing, you will help to conserve natural resources and improve standards of environmental
protection in treatment and disposal of electrical waste.
PROBABLE CAUSE
Saline solution got inside of the base
The DEVICE is on unstable surface
The saline solution got inside of the base
over the fan
The outside surface of the water tank
remained wet or the cover was removed
between refills.
Cover or inner cover not installed properly
Device has been tipped over
Low temperature or high humidity
Notes on the signs
Class II equipment
Indoor use only
Consult instructions for use
5
SOLUTION
Clean the device and let it dry for
12 hours in a cool, dry place
Move the DEVICE to a stable,
perfect level surface
The DEVICE needs repair
Wipe the DEVICE dry after refill
and do not remove the cover
between refills.
Remove and re-install correctly,
so vapors can be released freely
Unplug, pour any water left, wipe
and let it dry for at least 24 hours
Under these conditions, the mist
may condense quickly into water
droplets. Assure proper air
qualities.