Timer; Care And Cleaning - Mitsubishi Electric M Série Manuel D'utilisation

4. Timer

■ Timer functions are different by each remote controller.
■ For details on how to operate the remote controller, refer to the appropriate operation manual included with each remote controller.
5. Care and Cleaning
► C leaning the filters
• Clean the filters using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the filters against a solid object to knock off dirt and dust.
• If the filters are especially dirty, wash them in lukewarm water. Take care
to rinse off any detergent thoroughly and allow the filters to dry completely
before putting them back into the unit.
Caution:
• Do not dry the filters in direct sunlight or by using a heat source,
such as an electric heater: this may warp them.
• Do not wash the filters in hot water (above 122 °F [50 °C]), as this
may warp them.
• Make sure that the air filters are always installed. Operating the unit
without air filters can cause malfunction.
Caution:
• Before you start cleaning, stop operation and turn OFF the power
supply.
• Indoor units are equipped with filters to remove the dust of sucked-
in air. Clean the filters using the methods shown in the following
sketches.
►Filter removal
Caution:
• In removing the filter, precautions must be taken to protect your
eyes from dust. Also, if you have to climb up on a stool to do the
job, be careful not to fall.
• When the filter is removed, do not touch the metallic
parts inside the indoor unit, otherwise injury may result.
► R emoval and replacement of filter
• Unscrew the two thumb knobs on the panel stamped "filter" tilt forward
and pull the panel out. Grasp the edge of the filter and slide out. Re-install
in reverse. (see Fig A)
4
■ MVZ-A·AA7
Filter
FILTER
Fig A