djive VACUMATE one PRO Mode D'emploi page 11

Assembly as an upright appliance
Hold the suction hose so that the electric contact rods are on the underside.
Now carefully push the suction hose into the hand module opening. The
electrical contacts then slide into the small openings on the hand-held part.
The suction snaps into place with an audible "click".
Now you can either attach the floor brush or the other cleaning attachments
to the other end of the suction hose.
The grout nozzle and the 2in1 furniture brush both have a small guide rail on
the underside. This must point downwards during assembly so that it can
slide into the notch in the round part of the connection. These attachments
also lock in with an audible "click".
Conversion
Press the electrical connection release button on the suction hose. Now
either the entire suction hose can be removed or only the respective cleaning
attachment at the other end using the second release button.
The flexible suction hose can
be pulled out and pushed
back together again.
The position of the foot can
be flexibly changed on the
upholstery brush.
11