AXIL AC 0541 E Manuel D'utilisation page 31

Installing ways of cement and beton wall
Put the wall mount flatly in the installing position, using it as template, lining out the
hole on the wall. Use a aiguille of dia 10.5 mm to drill three 50 mm deep holes. Insert
the wall anchor (I) into the mounting holes, and lightly tap them flush to the wall with a
hammer. Securely mount the wall plate with supplied Long bolts (G) and washers (I) by
Box wrench (L). As shown in Fig. 2.
Carefully: Wall anchor is just fit for cement and beton wall. Don't use wall anchor in
drywall to install bracket.
I
Balance-adjusting
L
50m m
G
H
10.5m m
Fig. 2
Using balance-adjusting system on the plate,
make sure whether wall plate is installed
balance. If not, then slide the wall plate let
pointer level in the center position.
Installing the Plastic Cover
Secure the separated Plastic Cover the Wall
Plate by pushing them toward each other until
they lock in place. See Fig. 3.
Fig. 3
31