Juliana Premium Instructions De Montage page 4

May we congratulate you on your new greenhouse
GB
DEAR CUSTOMER Dear Customer!
Congratulations on your dwarf wall. Please follow
The assembly of your new house requires
the instructions step by step to install your dwarf
a bit of technical knowledge. However, it is
wall.
important that the assembly instructions are
followed strict-ly. The assembly instruction
All detailed illustrations are marked with the
is a combination of text and illustrations. The
following symbols:
profiles are packed in separate numbered packs
corresponding to the order in the assembly
instruction. Erect one pack at a time. All nuts
Seen from the inside Seen from the outside
and bolts and fittings are found in bag No. 0
SOME SAFETY PRECAUTIONS
(specified on page 12). Each pack is specified in
• It is advisable to construct the wall in dry,
separate lists of components.
calm weather.
All detailed illustrations are marked with
• You will need someone to help you.
symbols:
PAGE 12: TOOLS
Assembling the greenhouse requires the tools
Seen from inside Seen from outside.
shown on page 12.
Precautions.
BASE
• Assembly must only be carried out in dry
The base is included as part of this delivery. Make
and calm weather.
sure the base is completely level and square. To
• Always use working gloves while glazing.
square the base, make sure the two diagonal
Greenhouse glass has sharp edges,
measurements are identical.
especially if the glass breaks.
You will need to dig holes to a frost-free depth to
• Assistants and especially children must be
attach the anchors for the corner/door and the
mid-section.
warned that broken glass is an element of
Approximately 75 litres of concrete will be required
danger. Pick up broken glass at once and
to secure the wall.
remove it with care.
• We recommend to use protective glasses
CLADDING
while fixing the spring wire clips.
- If you have opted for wood/tile cladding, this
• Place the ladder on a level support.
can only be applied to the outside, and this must
• It is essential to have an assistant.
be done before the sheets are positioned on the
inside, as a batten of wood is required on the inside
of the sheet to give some purchase to the fixing
References
screw.
The column marked indicates the
- If you have opted for a brick veneer, it is advisable
page(s) on which the component is used.
to apply a suitable sealant to the material to reduce
cracking due to frost.
Page 13:
- If you have opted for a rendered finish, you
Foundation
must use render that 'yields' – possibly over mesh
The base is not included in this delivery.
reinforcement (ask your local DIY store for advice).
However, an original base can be bought
It is advisable to seal the render to reduce moss
formation.
separately. It ensures you a stable and easy to
build base.
INSURANCE
If you make your own base the measurements
Please note that not all insurance companies cover
indicated must be external measurements.
greenhouses automatically. Please contact your
If you buy an original base you furthermore
insurance company to ensure that your greenhouse
need about 75 litres of concrete and 6/8
is covered.
plastic-/concrete pipes of about 800 mm which
are placed in a non-freezing depth for the
GUARANTEE
Juliana greenhouses are covered by a 12-year
fastening of the corner and middle anchors.
guarantee, which covers the replacement or repair
The base must be 100% level and square; the
of faulty parts. The guarantee does not cover
latter is ensured by checking that the two
polycarbonate, glass, transport, assembly, freight,
diagonal measurements are equal.
etc.
Juliana greenhouses are covered by a two-year
Tools
warranty on painted parts, where fitted. Note that
The mounting of the greenhouse requires the
marks on the paint may occur due to suspension of
tools shown on page 12.
the profiles.
The guarantee will be void if the greenhouse is not
assembled in accordance with these instructions.
Page 14-27:
Place the components as shown on the
illustration and assemble in the order shown
in the pictures. Do not tighten the nuts
completely until the front gable construction
has been assembled.
COMPLAINTS Page 13:
All our greenhouses are built to the highest quality
(Fastening to the base).
standards. However, should you experience any
When constructing your own base you have
problems, please contact your dealer at once.
to drill holes (7 mm) in the ground frame
When describing the defect, please state the
between all the vertical frames, the greenhouse
greenhouse model, the component number and
is then fastened to the base with screws (A).
the quality control number.
Using an original base the greenhouse is
fastened to each vertical bar as shown on
Any suspension marks or shiny ends on painted
Juliana profiles will not be visible after the drawing B/C.
greenhouse has been assembled.
Page 24-27:
Congratulations on your new greenhouse, which
For an easier assembly we recommend that you
we hope will bring you a lot of pleasure for many
oil the screws for the doors.
years to come.
Fitting of glass/polycarbonate
Yours sincerely,
Important before glazing!
Juliana Drivhuse A/S
Make sure that gables and sides are level and
square, and that door(s) and window(s) are
functioning perfectly.
Best order of assembly:
1) Windows – 2) Roof – 3) Doors – 4) Gables
– 5) Sides
Page 30-33:
Glazing (illustration 1 to 8)
Degrease the sheets and frames with spirit.
Start glazing from below, one glass at a time.
Apply a 3 mm silicone line on the vertical
frames where indicated (dotted lines on
the illustration). (A 3 mm line of silicone is
sufficient to obtain maximum attachment). If
you do use more than recommended, you can
buy extra tubes.
Spring wire clips and glassholders are to be
fitted as shown.
X = Spring wire clips, > = Glassholders
In case of broken glass carefully pull it
outwards and loosen the silicone by means of a
sharp craft knife.
Clean the profile completely before inserting a
new pane of glass.
Page 34-37:
Mounting of polycarbonate
The illustrations at the bottom of page 34/36
show where to mount the polycarbonate plates
and lists. The type indication states the length
in mm. A possible adjustment is made by
means of a fine-tooth saw.
NB! To avoid the formation of algae the
polycarbonate sheets must not come into
contact with the ground. Rest them on a piece
of cardboard.
A-lists are mounted as shown on page 35/37.
Put the sheet into the bottom list, bend the
sheet slightly outwards and put it in the top list.
M-lists are mounted as shown on page 35/37.
Place the upper part of the list under the alu.
profile in the whole length of the sheet and
hereafter click on the list from above.
B
Sealing of the polycarbonate sheets
The sheets may be sealed against insects.
Close the top end off with alu-tape or silicone.
The bottom only with airstrip tape to let
condensation out (available at your local
dealer).
Now your greenhouse is completely assembled.
However, please notice the following:
Maintenance
• Grease doors (hinges and lock).
• Clean the gutter for leaves, etc.
• Adjustment of windows.
• Replacement of broken glass.
• Clean the house with disinfectant before
and after the growing season.
Winter Protection
In areas with occurrence of snow we
recommend the following winter protection:
• Support the roof ridge at the centre of the
house.
• Remove greater snow loads from the roof.
• Take precautions against snow falling
down from for instance a tree or a roof.
• Dismount the cylinders for the automatic
window openers, if any (optional extras).
• Secure door(s) and window(s) preventing
wind damage to the house.
Insurance
Please note that not all insurance companies
cover glasshouses automatically. Please
contact your insurance company to ensure an
insurance coverage.
Guarantee
Juliana grants a guarantee of 12 years which
covers replacement of faulty parts. The
guarantee does not cover polycarbonate, glass,
transport, assembly, freight etc.
Juliana grants a guarantee of 2 years on painted
parts, if any. Note that marks in the painting
may occur due to suspension of the profiles.
The guarantee is invalid if the greenhouse is
not assembled according to these instructions.
Complaints
All our greenhouses are built to high standards
of quality. However, should a complaint
occur please contact your dealer at once.
Remember to specify the defect by indicating
the greenhouse model and number of the
component and the quality control number.
USA