Led Display; Eco Function - Qlima RG10 Manuel D'utilisation

LED-DISPLAY:
Press LED button.
Press this button to turn on and turn off the display on the indoor unit.
Press this button more than 5 seconds(some units)
Keep pressing this button more than 5 seconds, the indoor unit will display the actual room
temperature. Press more than 5 seconds again will revert back to display the setting
temperature.

ECO FUNCTION

Press this button to enter the energy efficient mode.
NOTE: This function is only available under COOL mode.
ECO operation:
Under cooling mode, press this button, the remote controller will adjust the temperature automatically
to 24°C, fan speed of Auto to save energy (only when the set temperature is less than 24°C). If the set
temperature is above 24°C, press the ECO button, the fan speed will change to Auto, the set temperature
will remain unchanged.
G
NOTE
Pressing the this button, or modifying the mode or adjusting the set temperature to less
than 24°C will stop ECO operation. Under ECO operation, the set temperature should be 24°C or
above, it may result in insufficient cooling. If you feel uncomfortable, just press the ECO button
again to stop it.
Silence function
Keep pressing Fan button for more than 2 seconds to activate/disable Silence
function(some units). Due to low frequency operation of compressor, it may result in
insufficient cooling and heating capacity. Press ON/OFF, Mode, Sleep, Turbo or Clean
button while operating will cancel silence function.
FP function
The unit will operate at high fan speed (while compressor on) with temperature
automatically set to 8°C.
NOTE: This function is for heat pump air conditioner only.
Press this button 2 times during one second under HEAT Mode and setting temperature of
16 C/60 F to activate FP function. Press On/Off, Sleep, Mode, Fan and Temp. button while
operating will cancel this function.
LOCK function
Press together turbo button and Humidity button at the same time more
than 5 seconds to activate Lock function. All buttons will not response
except pressing these two buttons for two seconds again to disable locking.
Remote-man_RG10 EU ('21) V2.indd 29 Remote-man_RG10 EU ('21) V2.indd 29
29
16-11-2021 17:15 16-11-2021 17:15