Battery Notes; Battery Disposal - Qlima RG10 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Slide the back cover from the remote control downward, exposing the battery compartment.
Insert the batteries, paying attention to match up the (+) and (-) ends of the batteries with the symbols
inside the battery compartment.
Slide the battery cover back into place.
G

BATTERY NOTES

For optimum product performance:
Do not mix old and new batteries, or batteries of different types.
Do not leave batteries in the remote control if you don't plan on using the device for more
than 2 months.
G

BATTERY DISPOSAL

Do not dispose of batteries as unsorted municipal waste. Refer to local laws for proper disposal of
batteries.
G
TIPS FOR USING REMOTE CONTROL
The remote control must be used within 8 meters of the unit.
The unit will beep when remote signal is received.
Curtains, other materials and direct sunlight can interfere with the infrared signal receiver.
Remove batteries if the remote will not be used more than 2 months.
NOTES FOR USING REMOTE CONTROL
The device could comply with the local national regulations.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not approved by the party responsible for compliance could void user's author-
ity to operate the equipment.
Remote-man_RG10 EU ('21) V2.indd 23
Remote-man_RG10 EU ('21) V2.indd 23
4
23
16-11-2021 17:15
16-11-2021 17:15

Publicité

Table des Matières
loading

Table des Matières