Before You Start; What's In The Box; Loading The Batteries In The Remote Control - Pioneer XW-NAV1-k Mode D'emploi

01

Before you start

Chapter 1:
Before you start

What's in the box

Please confirm that the following accessories
are in the box when you open it.
• Remote Control
• Audio/Video cable
• Power cord
• FM wire antenna
• AA batteries (R6) x 2
• Operating instructions (this document)
Loading the batteries in the
remote control
1 Slide the rear lid in the direction.
Slide in the direction of the arrow ().
2 Open the rear lid.
1
2
6
En
3 Insert the batteries as shown on the
diagram below.
4 the rear lid.
Close
Caution
• Do not use any batteries other than the
ones specified. Also, do not use a new
battery together with an old one.
• When loading the batteries into the remote
control, set them in the proper direction, as
indicated by the polarity marks ( and ).
• Do not heat batteries, disassemble them,
or throw them into flames or water.
• Batteries may have different voltages, even
if they are the same size and shape. Do not
use different types of batteries together.
• To prevent leakage of battery fluid, remove
the batteries if you do not plan to use the
remote control for a long period of time (1
month or more). If the fluid should leak,
wipe it carefully off the inside of the case,