Whirlpool WHP0400VW Instructions D'installation page 4

Uninstalling your gas dryer
1. Unplug the power supply cord or disconnect power.
2. Turn off the gas supply.
3. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
4. Disconnect the flexible gas supply line from the dryer. Put a
piece of tape over the open ends of the gas line connection
fittings.
5. Pull the dryer away from the wall so that it can be tipped on
its back.
6. Protect the floor with a large piece of cardboard cut from the
pedestal carton. Lay the dryer on its back (make sure that the
power supply cord is not under the dryer) so that the
cardboard is under the entire lower back edge of the dryer.
12"
(30.5 cm)
15"
(38.1 cm)
7. Go to "Installing the Pedestal" section.
4
Washer or dryer is still in its packaging
1. Position the packaged washer or dryer close to its final
position. Cut the packaging as follows:
Washer: Cut plastic film along dotted cut line around the
base. Do not remove the packaging. Do not remove the
shipping bolts at this time.
Dryer: Cut carton around top and down corners along dotted
cut lines. Lay all four carton sides on floor. Discard carton top
and corner posts.
IMPORTANT: Leave carton bottom underneath dryer.
2. Lay washer or dryer on its back.
NOTE: When laying the washer on its back, hold the bottom
cap down on the floor. Do not remove the plastic film, corner
A
posts, or top cap. These protect the floor and washer back.
When laying the dryer on its back, the floor and dryer back
are protected by cartoning.
A. Cardboard
A
A. Carton sides