V23 Flush Receiver - Fenix V23 Manuel

GB
1. Presentation
- The V23 receiver is a Wall mounting receiver, specially designed to control electrical floor heating regulation in combination
or not with a wireless thermostat V22 type.
- This couple (Thermostat Receiver) can also be managed by a Central V24 to have full control of your heating installation
from one point.
- Possibility to connect a floor sensor directly on this unit (For regulation or floor limitation).
Output LED (Red)
Red: Heating demand
Blink: Floor sensor error
RF Configuration button
Short press: Instantaneous RF transmission
3sec press: Thermostat or Central RF init.
5sec press: Slave receiver init.
15sec press: Reset of the receiver.
2. Technical characteristics
Environment. (Temperatures)
Operating :
shipping et storage :
Power supply
Electrical protection
Pilot wire Input (French market)
Output
Maximum Load
Radio Frequency &
RF Receiving distance
Optional Floor Sensor
Norms and homologation:
Your thermostat has been designed in
conformity with the following standards or
other normative documents:

V23 Flush Receiver

Option: Floor Sensor
NTC 10kOhms at 25°C
0°C - 40°C
-10°C to +50°C
230Vac 50Hz
Class II - IP20
Option: insulation clip for IP21 protection
6 orders Pilot Wire by phase (L)
Relay 16Amps 250VAC
Up to 16A - 250Vac 50Hz (2 wires L,N)
868MHz < 10mW (Bidirectional communication)
Range of approximately 100m in open space.
Range of approximately 30m in residential environment.
NTC 10kOhms at 25°C
EN 60730-1 : 2003
EN 61000-6-1 : 2002
EN 61000-6-3 : 2004
EN 61000-4-2 : 2001
EN300220-1/2
EN301489-1/3
R&TTE 1999/5/EC
Low voltage 2006/95/CE
EMC 2004/108/CE
6
Status LED (RED/Green)
Green:
Fixed: RF configuration
Flash: RF reception
OFF: Standby
Blink: RF Alarm
Red:
Fixed: Floor Limitation
Red/Green (Orange)
Fixed: Pilot wire information.