Mitsubishi Electric CITY MULTI PLFY-EP NEMU-E Manuel D'utilisation page 15

4. Operation (For Simple MA remote controller)
Preset temperature range is as follows.
Operation mode
COOL/DRYING
HEAT
AUTO (single set point)
AUTO (dual set point)
SETBACK
FAN, VENTI.
*1 The preset temperatures for cooling and heating for AUTO (dual set point) mode will be used for those for COOL/DRYING and HEAT mode.
*2 The preset temperatures for cooling and heating can be set under the following conditions.
• The cooling preset temperature is greater than the heating preset temperature.
• The difference between the cooling and heating preset temperatures is equal or greater than the minimum temperature difference that varies depending on the
indoor unit model to be connected.
4.3. Fan speed setting
Pressing the button will change the fan speed in the following order.
FAN
AUTO
* The settable fan speed varies depending on the indoor unit model to be connected.
* If the unit has no fan setting function, the fan speed cannot be set.
In this case, the fan icon blinks when the
4.4. Vane setting
Pressing the button will switch the vane directions.
VANE
AUTO Setting 1 Setting 2
* The settable vane direction varies depending on the indoor unit model to be connected.
* If the unit has no vane function, the vane direction cannot be set.
In this case, the vane icon blinks when the
Preset temperature range
67 - 87 (95)°F/19 - 30 (35)°C
63 (40) - 83°F/17 (5) - 28°C
67 - 83°F/19 - 28°C
[COOL] Preset temperature range for COOL mode.
[HEAT] Preset temperature range for HEAT mode. *1, *2
[COOL] Preset temperature range for COOL mode.
[HEAT] Preset temperature range for HEAT mode. *2
Unsettable
button is pressed.
FAN
Setting 3 Setting 4 Setting 5
button is pressed.
VANE
Swing
en
14