Safety Functions; How To Use The C-Pack Batteries; Important Instructions For Use - therm-ic C-PACK 1300 Mode D'emploi

INSTRUCTIONS FOR USE / ENGLISH
does not need to be fully discharged before
charging.
• When starting the charging process, the C-Pack
battery should be in POWER OFF mode.
• The full charging capacity of the C-Pack batteries
can only be conserved if the C-Pack batteries
are removed from the charging station after the
charging procedure is complete.
Charging times
Battery
Charging time
Note that at half time of the charging time mentioned
on table above, the battery is already charged at
around 75% of its maximum capacity (fast charging
process). Lab test done using Therm-ic USB wall plug
universal charger (optional).

SAFETY FUNCTIONS

• Short circuit protection: If a short circuit occurs on the
connector or heating element, the integrated electronic
C-Pack 1300 C-Pack 1700
~ 6h00 ~ 8h00
circuit switches off the C-Pack battery. After removal
of the short circuit and brief insertion into the charging
shaft, the C-Pack battery is ready for use again.
• Protection against overcharging and exhaustive
discharge: The C-Pack battery is protected against
overcharging and exhaustive discharge by the
integral electronic circuit during use.
HOW TO USE THE C-PACK BATTERY
• When using the C-PACK, connect the cord from the
heated insole firmly to the C-PACK.
• The C-Pack battery can be controlled with button
(1.3) or with a iOS and Android app (only for C-Pack
Bluetooth® enabled).

IMPORTANT INSTRUCTIONS FOR USE

• Do not allow the highest heat level to be switched
on for more than a few minutes at a time. This could
produce too much heat during operation, which
may cause burns.
• Always set C-Pack battery to low or moderate heat
levels to maintain comfortable foot warming (heating
should be almost undetectable).
10