Honeywell HS-160R Serie Manuel Du Propriétaire page 3

ASSEMBLY INSTRUCTIONS
BLADE KNOB (F)
CLIPS
(G)
FAN BLADE
GRILLE
HUB
FRONT GRILLE
METAL
POLE
BASE EXTENSIONS
(A)
BASE
ROUND BASE
First look to see if your fan has a cross base or a round
base, and then follow the base assembly instructions for the
fan you have.
FOR CROSS BASE
• Place Base Extensions (A) as illustrated and push down
hard to snap Base Connector (B) firmly onto Base
Extensions (A) (Fig. 1).
• Insert the Metal Pole (C) into the Base by lining up the
recessed slot in the Pole to the raised dot on the Base
Connector and push in. Be sure that the Pole is fully
seated. Hold the Base firmly and twist the Pole
CLOCKWISE 90° until it stops. DO NOT OVER-TIGHTEN
(Fig. 2).
FOR ROUND BASE
• Insert the Metal Pole (C) into the Base by lining up the
recessed slot in the Pole to the raised dot on the inside of
Base and push in (Fig. 3). Be sure that the Pole is fully
seated. Hold the Base firmly and twist the Pole
CLOCKWISE 90˚ until it stops. DO NOT OVER-TIGHTEN.
REAR GRILLE
REAR GRILLE (E)
MOUNTING
NUT (D)
MOTOR HOUSING
TIMER SPEED
2 4 8 L M
H
MANUAL CONTROL
BREEZE
PANEL
TIMER
SPEED
OFF
BREEZE
SPEED
TIMER
OFF
REMOTE CONTROL
BASE
METAL
POLE (C) CONNECTOR (B)
CROSS BASE
Fig. 1
B
A
Fig. 2
C
RECESSED
SLOT
Fig. 3
C
RECESSED
SLOT