Changing Needle - Kasanova CIH000005 Manuel D'instruction

10 SEWING MACHINE AND SEWING KIT
3. Position fabric to be sewn under the presser foot with presser foot in raised
position. Make sure seam direction is aligned with the presser foot and with
seam location.
4. Lower the presser foot.
5. Select speed by pressing speed button on the front of the machine. High
speed, button is in. Use low speed for difficult projects which require a lot of
stopping and turning fabric. Use high speed for long uninterrupted seams.
6. Turn power switch to ON position,{Note: When using the foot pedal, the ma-
chine should be on OFF and would only work when you press the pedal.)
7. Gently guide the fabric to keep the seam straight by pressing lightly down
with your fingertips on both sides as if feeds through the presser foot.
8. When the seam is finished, turn power switch off.
9. Raise the needle above the fabric by turning the hand wheel slightly in a
clockwise direction.
10. Raise presser foot by lifting the presser foot lever.
11. Pull fabric towards you leaving about 10 inches of thread between the fabric
and the machine.
12. Cut thread close to fabric, leaving excess thread loosely lying on the sewing
deck in the direction of the presser foot ,towards you.
ADJUSTING TENSION
1. Tension for maximum performance has been set and adjusted by the
factory. However, if you find that stitches are too loose or too tight, you can
adjust the stitch.
2. Loosen stitch by turning the tension screw counterclockwise.
3. Tighten the stitch by turning the tension screw clockwise. Sewing heavier fa-
bric may require loosening the stitch. Very light fabric may require tightening
the stitch. Bobbin tension cannot be adjusted.

CHANGING NEEDLE

1. Turn the head wheel clockwise to raise the needle to its highest position.
2. Loosen the needle clamp screw by turning it counterclockwise. you may
need to use a short slotted screwdriver or small piece of metal(e.g. dirne).
3. Remove the needle, pulling down, away from the needle clamp.
4. Place the new needle with the flat side facing in against the needle clamp.
Push it gently as far up as it will go.
5. Tighten the needle clamp screw while holding the needle in place.
Note: Needles come in various sizes designated by numbers. The smaller the
number, the thinner the needle. Use smaller needles for more delicates fabrics