Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product Information: Cordless Die Grinder - GS25 and GR25
Product Safety Information
Intended use:
These Cordless Die Grinders are designed for grinding, porting, polishing, sanding, de-burring and breaking sharp edges.
Responsibly recycle or dispose of Batteries. Do not puncture or burn Batteries. Improper disposal may endanger the environment or
•
cause personal injury.
•
Only use Tools with appropriate voltage Ingersoll Rand Batteries and Charger. Use of any other batteries may create a risk of fire,
personal injury or property damage.
This is a class A product. In a residential, commercial or light industrial environment it may cause radio interference. This product is
•
not intended to be installed in a residential environment; in a commercial and light industrial environment with connection to the public
mains supply, the user may be required to take measures to reduce interference.
For additional information:
Refer to Cordless Die Grinder Product Safety Information Manual Form 45502192, Battery Charger Safety Information Manual
Form 10567832 and Battery Safety Information Manual Form 10567840.
Manuals can be downloaded from www.ingersollrandproducts.com
Product Specifications
Voltage
Model
V, DC
GS25
14.4
GR25
14.4
* Where available
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
* K = Vibration measurement uncertanity
Product Operation
This tool is equipped with an overload protection device that prevents damage to the motor due to stall and overheating. If the tool
reaches an overload condition, the tool will shut-off. When shut-off occurs, the trigger lever must be fully released and then pressed again to
restart the tool.
When approaching the over temperature limit, the tool will begin to pulse. In this condition it is recommended that the tool be allowed to cool
before resuming normal use. If the over temperature limit is exceeded, the tool will be temporarily disabled. In this condition the tool must be
allowed to cool before resuming normal use.
Parts and Maintenance
For routine maintenance, inject 2 cm
All other maintenance and tool repair should only be carried out by an authorized Service Center. For the nearest location, visit
www.irtools. om/locator.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
45619418_ed2
Max. Power
Free Speed
(rpm)
HP
27500
0.35
20000
0.35
of Ingersoll Rand #67 grease into the angle head every week, or after every 8 hours of operation.
3
WARNING
Sound Level dB (A)
Collet Size
inch
mm
† Pressure (L
1/4
6*
70.4
1/4
6*
72.5
(EN60745)
m/s
)
‡ Power (L
)
Level
p
w
81.4
2.8
83.5
4.6
EN
Vibration
(ISO28927)
2
*K
0.8
1.7
EN-1
Publicité
Table des Matières
